This is a monoblock chassis.
The rear panel has not been pre-cut, you will need to DIY.
Heatsinks
This chassis has two UMS heatsinks on one side. There is no official 4Ux400 UMS pattern. For this offering, the heatsinks have the 5Ux400 UMS pattern drilled and tapped into them. The pattern has been centered vertically rather than offset, and there are two extra holes that allow the pattern to also be used upside down.
Thanks to Patrick of Thuss and Farrell for his contributions to the initial design concepts.
| Height (mm) | Width (mm) | Depth (mm) | |
|---|---|---|---|
| Internal |
159
|
230
|
400
|
| External |
165
|
310
|
410
|
| Faceplate |
165
|
280
|
10
|
| Heatsinks |
Two 40mm thick x 200mm deep (400mm total depth), wave profile, black anodized aluminum heatsinks on one side only, drilled and tapped with UMS style pattern
|
||
| Side panels |
3mm black anodized aluminium
|
||
| Covers |
3mm black anodized aluminium |
||
| Front Panel |
10mm silver anodized aluminum
|
||
| Rear Panel |
3mm black anodized aluminium
|
||
Dimension diagram